• CNC Machinine 3 Axis Controller

Minitech’s advanced stepper driver is based on a DSP with an advanced control algorithm. It brings a high level of system smoothness, providing optimum torque and nulls mid-range instability. Motor auto-identification and parameter auto-configuration technology offers optimum responses with different motors and is easy-to-use. The driven motors can run with much lower noise, less heating, smoother movement than most of the drivers in the markets. Its unique features make the driver more attractive.

Key Features

  • High Performance, Based on DSP Algorithm.
  • Anti-Resonance, provides optimum torque and nulls mid-range instability
  • Motor auto-identification and parameter auto-configuration technology, offers optimum responses with different motors
  • Multi-Stepping allows a low resolution step input to produce a higher microstep output for smooth system performance
  • Microstep resolutions programmable, from full-step to 51,200 steps/rev
  • Can be set by Dip switch (2,4,8,16,32,64,128,256,5,10,25,50,125,250)
  • Supply voltage up to +36 VDC
  • Output current programmable, from 0.5A to 4.2A(Can be set by Dip switch too)
  • Pulse input frequency up to 200 KHz
  • TTL compatible and optically isolated input


PC Interface
Ethernet Interface
Drive Type
Digital bi-polar chopper, 10 amp with micro-stepping setting, 125x micro
Number of Drives
5, with 5-axis simultaneous control
Power Input
110 VAC (220 VAC), converts to 40 VDC
Memory Type
Non volatile memory
Interface
TTL signal from serial port (RS 232), all cables included
Input Logic
Up to 8 input TTL signals
Output Logic
Up to 8 output for limit, home or safety switches
Spindle Speed
Include module for RPM control by CNC control software M Code
Spindle ON/OFF
Include module for ON/OFF control by CNC control software M Code
Home Sensor
Include module for reading input of up to 5 axis of home and Tool Probe sensors
Driver Modes
Standard step modes: 1:125 micro-stepping mode, 10,000 steps per revolution


Write a review

Note: HTML is not translated!
    Bad           Good
Captcha

CNC Machinine 3 Axis Controller


Related Products

CNC Milling Machine, 60,000 RPM Spindle, Benchtop Style,  For Mold  or Microfluidic Chip Micromachining

CNC Milling Machine, 60,000 RPM Spindle, Benchtop Style, For Mold or Microfluidic Chip Micromachining

The Minitech CNC Mini-Mill/GX is an affordable precision-ground, granite frame, micro machining syst..

Tags: CNC Machine, Micromachining, Mold Insert, Microfluidics